New RO Installation, Done Right the First Time
A water purifier is only as good as its installation. Loose fittings, wrong tubing pressure and rushed wall-mounting are the reasons a brand-new RO develops leaks or low flow within weeks. Our technicians install domestic and commercial RO systems with correct pre-filter sequencing, pump calibration and TDS-controller tuning, so the unit performs at its rated capacity from day one.
Common signs you need installation
How our installation process works
Site & water check
We check input TDS, water pressure and existing plumbing before recommending a mounting point.
Mounting & plumbing
Wall-mount or under-sink fitting with leak-tested inlet, outlet and drain connections.
Filter sequencing
Sediment, carbon, RO membrane and post-carbon stages fitted in the correct order for your source water.
Calibration & test run
TDS output, flow rate and auto shut-off tested before we hand over the unit.
Frequently asked questions
How long does RO installation take?
A standard domestic installation takes 45–60 minutes once the site is ready. Commercial and multi-stage systems can take 2–4 hours depending on plumbing complexity.
Do I need to buy the purifier separately?
Yes, we install purifiers you've already purchased from any brand — Kent, Aquaguard, Livpure, Pureit and others — or help you fit a reconditioned unit if requested.
Will you check my water TDS before installing?
Yes. We test source TDS on-site and recommend the right membrane stage so the purifier isn't over- or under-filtering your water.